Dual Battery Kit - DCDC + 100 amphr Lifepo 4 Slimline Battery
Tough Touring Dual Battery kits consist of a Victron xt50 DCDC charger, Cable Looms, Cable Glands, Sheathing, a 100amphr Lifepo4 Battery and face console with USB A,B,C, Twin Anderson Ports - All fused to AU spec and ready to install...
THE CHARGER
Victron xt 50 DCDC Charger included. Programmable via App on Iphone (Victron connect) .
THE FACE CONSOLE
3d Printed Flush mount base plate with USB A,B,C - Twin anderson ports - (one for the fridge and one for another appliance/ Travel Buddy?)
LED volt meter/Guage
THE CABLING
20mm AU Spec leads with Cable lugs and Cranking battery MIDI fuse protected.
THE BATTERY
Size :285 (h) x 110 (thick) x 390 (long)mm (Slimline)
The Battery can be used safely in conjunction with 1200w Inverters - (In Lieu of twin 100Amp hr Lifepo4 batteries) - should you wish to add one later - you can do this.
The supplied "forever powered AGA" Lifepo4 batteries achieve a higher constant load output offering that extra bit of leeway when using just over 1000w appliances /items. Covering most of the common handy appliances available on the market - including small toasters, Kettles, Coffee machines, Pressure cookers, Rice Cookers, TV's and Jaffle makers... Making this battery size more than enough to cater for most 4wd offroad adventures with a few extra comforts,
OUR TESTING
These batteries have been tested until we melted them - Smashing them with deliberate OVER power / running at 2000w - for prolonged 30 minute bursts.
Even when tested to limits - (Well over 140Amps from the battery) - These batteries delivered 80 amp hours of power before hitting cut out voltage of 11.5Volts. Almost 35 Minutes of massive release.
This is a maintenence free battery - It can be run flat and stored flat without harm - however all Lifepo4 Batteries are reccommended to be stored long term at half charge...Float Levels on this battery are 13.6Volts. The Battery Should be considered Flat at 12 Volts.
Voltage levels will drop during heavy discharge. (and Return again afterward) If discharging the battery lowers the battery below 12 volts - this should be considered to much power drain, and the appliance turned off / not used again.
In The Event of Misuse - The Built in BMS (Battery Management System) will cut out before dangerously low battery levels are reached shut down power completely for 15 seconds before an attempt at restarting... The Appliance causing the Large Discharge should be switched off to allow the battery to restart.
It is reccommended that the battery be charged with a dedicated Lifepo4 charger and settings on charge voltage are set to 14.5Volts.
Specifications
ELECTRICAL SPECS
Nominal Voltage 12.8V
Nominal capacity 200Ah
Energy 4580WH Internal
Resistance 20MΩ
Self Discharge Voltage Window
Cycle life Maximum Modules in Parallel or series T
BD CHARGING/CC-CV Recommended
Maximum Advised charge current 100A
Standby Use 13.8-14V
Cycle Use Max Charge Voltage 14.6V
Balancing Volate Balancing Current NA (Self managed)DISCHARGE Specifications
DISCHARGE RECCOMMENDATIONS
Max Continuous Discharge Current 200A
Recommended Discharge Current 40A for Maximum Battery Life
Peak Discharge Current 400A
Low Voltage disconnect 10V
BMS Cut-off Voltage Short Circuit Protection Built In to BMS
MECHANICAL Weigt/KG 22Kg
Dimensions(L*W*H) 550x115x320mm
Terminal/mm M8 Container material ABS+PC
IP Rating IP65 Cell of Type LiFePo4SAFETY
OPERATING CONDITION BUILT IN CIRCUIT PROTECTION
LifePo4 Stable Cells.
Battery Management System(BMS)is incorporated against abuse.
Suitable for use in a wider range of applications where ambient temperature is unusually high: up to+60°C.8V 1200A/250uS Charge Temperature 0℃ to 45℃(32℉ to 113℉) @60±25% Relative Humidity Discharge Temperature -20℃ to 60℃(-4℉ to 140℉) @60±25% Relative Humidity