Tough Touring makes a Super Low mount , outward folded roof rack specifically for fittment of Roof top tents for  the Y62 - Attention has been taken to getting this rack as low and strong as possible while allowing for slight opening of the Sunroof - 
 
This rack design Can be set up to  allow the roof top tent and planks to be removed from beside the vehicle via 4 Captive  bolts each side  - Removing the entire set up in minutues and leaving the vehicle with Bare roof and only the rack feet... 

If your Going to run a low sidewalll Roof top tent - or a plastic tent and cannot ensure tent stiffness for Pole less wing install - see the information page here on options to install your Pole less wing awning directly to the rack (Independently to the tent) - https://www.toughtouring.com.au/tent-to-vehicle-kitsLess
 
Vital Statistics:
Roof Bar Width - MIN 1450mm ID 1210mm on Outfold Rails, 1370 mm on infold rails. 
 4 Single Planks Used on test vehicle - No wind noise reported running Bush Co Alpha Tent.
Feet - 3 each side 
Wagon Feet tabs angled inwards 75 degrees 
Roof rail Fold 71 Degrees
SMALL Rack feet to be installed as Roof cavity cover is stainless steel coated in plastic wrap and it cannot be cut. 
No Spacer Blocks required. 
Roof Holes - 6 x M8 already factory fitted... Each dide
 
Sikka 221 Used to caulk/seal bolts. 
12x 30mm Dome nuts (HT) Used to Bolt feet down, Remaining bolts used on Feet to Rails, and Planks to Rails all 20mm HT dome bolts with Nyloc Nuts and Stainles washers. 
 
We would Reccommend Fitment of your awning directly to the side of the roof top tent on this vehicle, however wider planks could be used up to 1550 as the y62 roof is square and wide - Independent awning could be fitted if RTT length was eual too or less than 2.1m 
 
Some examples of reccommended fitment of awnings to tent are here - https://www.toughtouring.com.au/tent-to-awning-brackets
These Kits are also listed on our Website for sale here https://www.toughtouring.com.au/product-page/tough-touring-awning-brackets-to-suit-bundutec-bundutop
 
THE y62 Roof rack kit contains: 
* 2 x Super Low y62 Roof rails - Folded Outwards at 75Degrees - 3mm Mild Steel / Powdercoated in Black Dulux Textura Paint.
6 x Seperate Rack feet , Customised for the y62 Stainless / Plastic wrapped insertion rail covers. 
ROOF RACK PLANKS:
 
 
4 x Roof Rack TOP HAT BAR PLANKS for ultimate strenth and Wider Planks / Anti Flex and easy tent removal and installation. 
 
* 12 x 30mm m8 High Tensile Hex Bolts , Nutserts and washers for rail mounting into the rail channels
* 12 x 20mm M* Bolts and Washers for bolting the Rail feet to the Roof rails.
1 x small Tube Adhesive sealant for Bolt Heads
16 x M8 - 20mm Countersunk Hex Head bolts and Nyloc nuts for fastening roof planks to rails. 
 
All components manufactured in High Grade Aussie Steel, Sand blasted for maximium paint durability and Finished in Dulux Black Textura Powdercoat and Baked at over 500 Degrees Celcius for Ultimate durability. 
 
Tough Touring Reccommends that these components are Fitted by a Professional Installer.