Toyota Troop Carrier  Shower cubicle Gutter Mount Kit.
The Kit comes in 3 variations -
 
'Stand alone Shower Awning Bracket Set'  - $790 (for customers not using our 270 Pole less wing awning gutter bracket) - This is a full kit with a Front and a REAR  new front awning mount bracket. These are typically used on Windowless Troopies where the shower cubicle needs to be mounted forward or at specific position. ) 
 
'Shower Addition' Kit - $395 (for customers adding the Shower cubicle to the rear drivers side as an addition to an existing Tough Touring 270 Gutter kit. The SHOWER ADDITION KIT requires you to re-use your existing hook bracket components, Replacing the hook with a larger one, as well as a new front mount )
 
The Tough touring Gutter Mount Shower cubicle kits allow you to Fit a Shower cubicle on the drivers side pf All Troopcarriers (Even Pop Tops) using the Troopcarriers Gutters,  They can be used to fit shower cubicles on High Roof or Pop top troopies, well within reach height of most customers arms for easy set up and pack down. 
 
 
If your adding this bracket onto an existing Tough Touring 270 Pole less awning kit (Cheaper option at $390) The Shower cubicle has to be installed at the rear drivers side in a fixed position - (It cannot be moved forward as the bracket shares the rear hook bracket). For totally free Shower cubicle installations - (The $790 option - you can install the shower cubicle Forward or in the middle for troopies with windows or pretty much anywhere for windowless troopies along the gutter length).- listed here  

Note - if your confused about the ''Shower addition that this Kit can be - you must already be running the Troop carrier Awning to Pop top bracket set listed here to use the "Shower addition kit"  here https://www.toughtouring.com.au/product-page/copy-of-toyota-troop-carrier-270-awning-gutter-moun-brackets

 
All Brackets finished in Black Dulux Textura Powdercoat , Baked at 500 Degrees Celcuis...The Bracket set comes complete with all mounting hardware and a tube of White Sikka Flex as to facilitate a dot to adhere the front supporting leg to the vehicle to prevent rattle.Awning mounting bolts are not supplied, as these vary immensely awning to awning and Your awning should have its own bolts included already supplied anyway. You will need a 13mm Spanner, 6mm Allen Key and a pair of scizzors/ sidecutters at the very least to effictively install the kit to your vehicle.This bracket set is immensely strong - Care should be taken to guy down and even Run poles on Pole less wing awnings in unprectable wind to ensure no damage is occassioned to your awning or vehicle should wind strength exceed the awnings load limits.

All Kits Come PRe-Assembled ready to fit. 
 
This kit fits all models of Troop Carrier from 1984 to present. However - Vehicles converted to Pop Tops or that have gutter modifications in any way can alter the gutter angles - Please check that your vehicles gutters have full width clearance and are not filled with Resign, Sealant or damaged by rust. 
Gutter area  where the brackets are to be fitted MUST BE  in good condition.  If they are not and you wish to run this bracket system, You risk failure.. (rust takes out the strength).
 
Suits 270 Degree Swing out Wing awnings up to 10 sqm, ONLY REAR  Pivot 270 Degree awnings are OK, forward pivoting awnings cannot be fitted. 360 Awnings cannot be fitted, Nor  can this bracket set be used for awnings that swing through Multiple Angles (ie. 270 at rear, 180 at front...) The Front bracket is not Twist resistant and cannot handle the loads of forward swinging awnings. 

Awnings in General that are Larger than 12 Sqm are not supported - as twist loads will exceed the troopcarriers Gutter Load capacity in strong wind and damage can occur. 
 
While all care has been taken to Ensure these brackets are as strong as we can make them - Tough Touring will not be responsible for Damage occassioned to your vehicle, awning or brackets due any damage occassioned by excessive wind - Or failure of any awning or bracket component over time. It is reccommended that Gutter integrity and Bracket  tightness s checked periodically to ensure fail safe use. 
 
Some Modifications may be required to Mounting Holes, Bolts, Spacers etc in use of Unsupported Brands of Awnings that we have not yet come across...Any use of an unlisted awning is at the owners discression and please let us know how you went, as were always looking to add more awnings to the supported list.